M.O.R.E. has developed this revolutionary new steering system for Jeep® YJ Wranglers with spring over axle (S.O.A.) suspensions systems. This Steering Correction Kit fits only Jeep® YJ Wrangler vehicles 1987-1995, with stock model 30 front axles and a spring over axle suspension system. Minor grinding and drilling/taping of knuckle required.
The stock Tie Rod and Drag Link are not up to the task of handling the angles or loads placed on them with the S.O.A. set-up, and they are very vulnerable to off road obstacles. Bump steer is a common complaint that we hear from customers, and worn-out Tie Rods and Drag Links are very common.

M.O.R.E. found it necessary to replace the stock set-up with all new components of a totally different design. We start with a new Tie Rod and Drag Link made of 1" O.D.x.219, D.O.M. steel tubing, threaded for Rod Ends (sometimes called Heim Joints) on both ends. The Tie Rod bolts on top* of the knuckles for increased clearance. The Drag Link bolts on top of the dropped pitman arm and parallels the ground, over the leaf spring to the passenger side knuckle. At that point, our special bracket bolts to the knuckle with six grade 8 bolts. Our raised and well reinforced Trac Bar Bracket keeps the Trac Bar (Slip-Loc or DoubleJointed) parallel to the Drag Link for zero bump steer.

This system is the answer to your steering problems. Designed for full suspension travel, without bind. It works with stock offset wheels, or after market. Simple bolt on design, no welding required. It will work with stock leaf springs over the axle, and for you folks who choose to use up to 2.5" lift springs over the axle. It does not come with steering stabilizer (shock) mounts.

All componets unpainted, or available, zinc plated tie rod & drag-link, for a slight additional fee.

It will not fit TJ's, XJ's or ZJ's. however, we do have a system in the works for these fine rigs. Jump to the bottom of this page for a "spy" photo. Stay tuned!

* In some cases, you must install a 1/2" tall block between the leaf spring and axle to allow clearance between the tie rod and spring, included with the kit.

*9921- Raised and well reinforced. This bracket only works with M.O.R.E.™ DoubleJointed or SlipLoc Trac Bars. Will not fit OEM (stock) trac bar !!!
**9922- Drilled for 5/8" Rod End.

***9923- Bolt on, drilling and tapping of knuckle required. No hardware or instructions provided!

****9924- With Rod Ends and Jam Nuts.

*****9925- All bolts, nuts, spacers, cotter pins, and instructions.

******9930- Includes: Knuckle Bracket (#9923), Tie Rod & Drag Link assembly (#9924), and Hardware Kit (#9925).

*******9940- Includes: Stage One components plus, Trac Bar Bracket (#9921), and Dropped Pitman Arm (#9922)